Our Business​

Main Features

1. It exhibits particularly excellent adhesive performance on substrates such as ABS materials, painted steel plates, and steel plates.
2. It also exhibits excellent adhesive properties on PP and PE materials, which are generally considered difficult to stick to, but please consult us regarding the type and conditions of use.
3. We can produce both long rolls and short plates. (However, for the W type, we only produce short lengths. Please contact us for information on materials and thicknesses that can be produced in long lengths.)
4. There are various urethane foam base materials to choose from depending on the application, including materials with excellent sound absorption and heat insulation properties.
5. The thickness of the urethane foam base material can be any thickness, starting from 3mm (maximum thickness 60mm).
6. Please consult us about post-processing such as punching into specified shapes and half cutting according to your needs.
7. The release paper also has low peel resistance, making it easy to use.
8. Since it is manufactured on a line dedicated to water-based adhesives, there is no need to worry about external contamination.

Main uses

• Sound absorbing material around the engine of construction machinery
• Sound-absorbing material around agricultural machinery engines
• Sound-absorbing material inside the generator
• Sound-absorbing material inside the printer housing
• For vehicles
• Pillars, roof insulators, air conditioner area (sealing material), radiator area, inside of front mirrors, harnesses

D type (direct adhesive)

Product number	Reinforcing core material	Features by type	Cross section
D-150 (Water-based adhesive)	None	The adhesive is directly applied to the foam body, and as it is relatively low cost compared to the R type, it can be used for a wide range of purposes. Compared to the R type, it has better ability to conform to finely uneven surfaces. The organic solvents that were previously used as solvents for industrial adhesives have been changed to water-based solvents, reducing the environmental impact of volatile organic compounds (VOCs), such as sick house syndrome. It can be used to reduce VOC and odors from double-sided tapes that use organic solvents. Direct adhesive may peel off if applied in a stretched state.
D-150W (Water-based adhesive)	None	The adhesive is applied directly to both sides of the foam body. It can be used to attach a foam body between two adherends. Please contact us as we may not be able to accommodate some substrates.

R Type "Type Features"

Product number	Reinforcing core material	Features by type	Cross section
R-800 (Water-based adhesive)	Nonwoven fabric	Compared to Type D, it has a larger amount of adhesive applied, resulting in better adhesion to the substrate. Generally, adhesive foam may peel off if applied in a stretched state. This R type uses reinforcing materials to prevent the foam from stretching, allowing it to be attached to the substrate with good dimensional precision and significantly improving adhesive performance. Even under harsh punching conditions, the adhesive does not sink into the foam, allowing for safe processing. This type contains a reinforcing core material and uses a water-based adhesive. It can be used to reduce VOCs and odors for double-sided tapes that use organic solvent-based adhesives.
R-810 (Water-based adhesive)	Nonwoven fabric	High-strength nonwoven fabric has no directionality when tensile, so it can be attached to the adherend with good dimensional accuracy. When applied to CR rubber sponge, etc., the nonwoven fabric core cuts out the effects of plasticizers that have a negative effect on the adhesive, preventing a decrease in adhesive performance. You can process freely without worrying about directionality during processing.